Mfd. 2015
Index control C200-SL with single NCU
Machine control panel equipped with a flat screen 47 cm
Carriage unit 1.1
X-axis and Z-axis NC controlled
Carriage unit 1.2
X-axis rigid, Z-axis NC-controlled
Carriage unit 2.1
X-axis rigid, Z-axis NC-controlled
Carriage unit 2.2
X-axis and Z-axis NC controlled
Carriage unit 3.1
X-axis and Z-axis NC controlled
Carriage unit 3.2
X-axis NC controlled, Z-axis manual
adjustable on X-axis and Z-axis NC-controlled
Carriage unit 4.1
X-axis and Z-axis NC controlled
Carriage unit 4.2
X-axis NC controlled, Z-axis manual
adjustable on X-axis and Z-axis NC-controlled
Carriage unit 5.1
X-axis and Z-axis NC controlled
Carriage unit 5.2
X-axis NC controlled, Z-axis manual
adjustable on X-axis and Z-axis NC-controlled
Carriage unit 6.1
Swivel axis and Z-axis NC controlled
The machine has an EC declaration of conformity and a CE mark
Bar feed: IEMCA SIR MS22/33/P, Bar length length 3300 mm (10ft)
UNIMAG – Interface for connecting a bar loading magazine
Synchronizing device layer 6.1 with workpiece ejection device and
Preparation for coolant supply through the synchronous spindle
Hainbuch Spanntop Axfix D22 for synchronous spindle
Rear processing device on slide position 6.2 for max. three drill holder pieces fixed tools
Oil/air lubrication for tool holders for one to maximum six units
Electrical preparation for an additional drive with an electronic shaft
(position-synchronous operation to the main and counter spindle)
Can be used for all additional drives with incremental encoders. single module
Electrical preparation for an additional drive without an electronic shaft only speed controlled. single module
High-frequency spindle with accessories (SycoTec)
Hinged belt chip conveyor 800 mm discharge height
Cooling lubricant tank, capacity 800 liters
Vacuum rotation filter, capacity 650 liters
Heat exchanger pump 80 liters/min 7 bar
Low pressure pump 300 liters/min 4 bar
High pressure pump 55 liters/min 40 bar
fire extinguishing system
Oil suction
Cooling unit